Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Trying to send the traffic from inside (higher security level) to outside (lower security level) using D-NAT & doing the Source Nat on the same Packet.This has worked fine in 8.2 but in 8.3 this cannot work with Auto-NAT and hence we have to configur...
If we are looking to get the username/ip/tunnel-group of the cisco ipsec ra vpn users connected to the ASA using SNMP
then we need to use this MIB "CISCO-REMOTE-ACCESS-MONITOR-MIB".
crasUsername (1.3.6.1.4.1.9.9.392.1.3.21.1.1) is the OID t...
Even after the license violation the traffic for all the users will be scanned by the module. Despite the error message that you are seeing, the CSC will not drop connections due strictly to license violations. It is only a warning at this point. Wit...
HI Paul,If thats ASA you can try this commandhttp://www.cisco.com/en/US/docs/security/asa/asa84/command/reference/s7.html#wp1333764show vpn-sessiondbPuneet
Here are the answers to your questions.1. Incoming TCP SYN packet arrives on fa0/1 and TCP session is built. I assume that this session will not be inspected ?2. TCP session is initiated from fa0/2 interface. Such session will be inspected - and afte...
