That's the strange thing...there was no tunnel interface configured on these devices.

Adam, Below is the error I was given :IP Removed:NP_500:Unable to push configuration to device ip IP Removed:FAILURE : [QoS configuration failed while pushing a CLI to the device: <![CDATA[%Tunnel1 used by PIM for Registering, configuration not allow...

That's what I thought should happen. I'm running 1.5.1.1054. When I reapplied the policy, all the switches that were green and had the policy applied have now errored out and are red. I am going to upgrade to 1.6.x and see if that doesn't fix this is...

Adam,Thank you for the response. I believe I could do that, but the problem is that I've created scopes based on buildings. When a new switch is brought online, I'd like to drop that switch into the scope for the building it's in and push the policy ...