Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,So I have an ASA 5505 that was working fine up until our gateway supplier changed it's firewall and where it was connected. Anyway since then we get an error saying "failed to locate egress interface" and i'm not sure why.Below is a sanitis...
We haven't readdresssed anything. As far as the config for the fw goes it has not been touched. The only thing I had to do post the migration was change a route on our core switches for the 172.x.6.0/24 network.So on the Datacentre SW we have a route...
Yes it is.Essentially we had the below (basic diagram)FW-------Core Switch----------Datacentre SW-------servers | | Old gatewayThe old gateway was a Cisco router that then connected to the providers datacentre. ...
Sorry the traffic from AAAA works fine. It traffic from sanmng that doesn't work.We have the below route that points traffic for Hitachi via out next hop.route inside 207.126.254.52 255.255.255.255 X.X.160.1 1
