About lcole

lcole · 02-18-2014

I just received a new RV320 V01 router and I am having trouble with the router loosing WAN and inter VLAN connectivity. Anywhere from 2 to 24+ hours the router will stop routing traffic to/from the WAN and other VLANs on the network. I have a ping tr...

lcole · 03-02-2014

The WAN2 port was disabled. As a test I turned the DMZ off again and made sure the WAN2 port was disabled as you noted. Within a few hours I started to have problems with the network and within 4 hours the router froze. Reset the router, turned on...

lcole · 02-25-2014

Found if I enable the DMZ that the WAN2 port becomes the DMZ port. I then made sure to disable the DMZ port. Everything has been working for three days. With DMZ disabled you have the two WAN ports with only the option of either load balancing or ...

lcole · 02-21-2014

Yes, a reboot or power cycle will fix the problem for the short term. It typically will reoccur but the frequency range of reoccurrence is very broad couple of hours to couple of days. I have not had a chance to try Marty's suggestion of resetting ...

lcole · 02-19-2014

You noted that the WAN 1 connection has no IP address when this occurs. When it occurred last, I noted the "Connected (Inactive)" on WAN1 and that there were no IP addresses assigned. I have a screen shot of the page attached. I had noticed the "Co...

Member Since	‎02-18-2014 05:21 PM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

RV320 loosing WAN and inter VLAN connectivity

RV320 loosing WAN and inter VLAN connectivity

Re: RV320 loosing WAN and inter VLAN connectivity

Re: RV320 loosing WAN and inter VLAN connectivity

Re: RV320 loosing WAN and inter VLAN connectivity