Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a problem with my SSH and cannot figure out why. Config below. I have some working and some not. There are no ACLs on the management switch. I can source ping from my Management VRF to the ISE servers and management IPsI've reconfigured my c...
REMOVE THIS:ip radius source-interface GigabitEthernet0/0 REPLACE WITH THIS:ip vrf forwarding Mgmt-vrf VERIFY WITH THIS:test aaa group ise-group username password legacy Works like a champ now.............
So for flapping... (not routing since there is no routing on the /24). Its hard to believe this is the case. This is the only switch with this issue. If ISE were flapping, I would see that on all other switches. My Gi0/0 cannot be flapping since ...
From the config above, (pasted below for your convenience) Gi0/0 is the management port on the rear of the switch next to the console.I can ping from the Mgmt-vrf (which is Gi 0.0) with the source ping to anywhere on my /24 management network. This ...
Not a routing issue. I can source ping from the Mgmt-vrf to the ISE server. Switch is directly connected via management port to the managment switch. I have a similar switch with pretty much the same config that works. Same code version and every...
Im using RADIUS. My solution is 100% working on the other switches in my network. This single switch fails 100% of the time. There is a communication issue somewhere, thus the logs that state my RADIUS server is marked as DEAD/ALIVE. I should see ...
