Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am going from a pix-515e to asa-5512-x. I used the wizard for the initial setup. I then set the interfaces the same, objects, nat rules, routes, ACLs the same as in the 515e (except for the outside interface ACL where you use the inside address ...
It looked like it was the ISP. It took a few minutes with the new ASA hooked up for computers to get internet activity. I noticed the computers on the dynamic nat had internet connectivity first, but the servers on static nats did not. I changed t...
