Please notes that where we are creating route-map to be used in NAT statement. There we will use match statement for interface also so that if both the conditions match only then traffic will be natted. Set statement is not needed there. Set is needed only when route-map is used to policy route traffic ip nat inside source route-map CELL3_PAT interface Cellular0/3/0 overload Inconrrect: ! route-map CELL3_PAT permit 10 match ip address 103 set interface Cellular0/3/0 ! Correct: ! route-map CELL3_PAT permit 10 match ip address 103 match interface Cellular0/3/0 !
... View more