Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi:I have a cisco ASA 5515X with two WAN connections and one LAN connection.As far as I understand, I hace the firewall configured to allow SMTP traffic through WAN2 interface, but not through WAN1. However, I'm having trouble sending email because t...
Hi: How do I setup the cisco ASA 5515 X so that it uses WAN interface B as a backup in case WAN interface A goes down? What if I wanted to balance both interfaces in order to sum up bandwidth? Thank you.
Hi all: I finally was able to go through the basic configuration of my new cisco ASA 5515 X (i'm completely new to cisco devices). I also managed to create VPN's to my two Amazon VPC sites. This was particularly hard because my ADSL Router which thi...
Hi all: I just got my new ASA 5515 X firewall and I got stuck in the first steps. I can ping a public IP (8.8.8.8) from the device but I cannot ping it from my LAN. I know I am missing either NAT rules or Access rules or maybe both, but I need some h...
Of course. Here you are. I hope it helps. If you do not have an ADSL router in front of the Cisco, like I do, you would simply replace 192.168.1.36 address with your public IP. And 192.168.1.1 with your default gateway IP.
I had the same problem, I think. Did you try to browse the internet from your PC? If yes, maybe you're missing a policy that allows the pings to go through. That's what happened to me. This worked for me: policy-map global_policyclass inspection_defa...
100% right. I'm embarrassed. I did reach the internet! I didn't even try to browse, only ping and ping and ping …After running that commands I can do both.Thank you so much.
