Hello I have a Problem with an an ACE4710 Setup. Between my 2 Ace's there are Switches which don't Support Jumbo Frames - Is there a way to configure the Interface on the ACE to an Standard MTU Sive (15xx) I'm using SW-Version A3(2.7).
Thanks, but this is not what I'm looking for. I want to change the MTU-Size on the Interface from 9216 to 1536. GigabitEthernet Port 1/4 is UP, line protocol is UP Hardware is ACE Appliance 1000Mb 802.3, address is 00:1b:24:5e:89:6c MTU 9216 bytes ...
