Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a Cisco ASA 9.1(3) 5545 device. A request from my customer required that a few servers in DMZ be accessible from outside. The details are as follows: Servers in DMZ: 10.20.30.40-49Public IP used for static NAT: x.y.111.1 - 10 The DMZ in...
Thanks jcarvaja, I had already configured the arp permit non-connected command. Even then it's not working. I'll try giving specific interfaces in the static NAT. Meanwhile, do you think routing the x.y.111.1 - 10 on the internet router towards the f...
