Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I did a upgrade on HA from 9.1.2 to 9.1.5, but after upgrade the lookup behavior has changed. on 9.1.2 it's NAT______packet-tracer input INSIDE tcp 10.10.0.10 5555 1.1.1.1 443Phase: 1Type: UN-NATSubtype: staticResult: ALLOWConfig:nat (INSIDE,OUTSIDEP...
It's the same NAT config on both box, I did a upgrade on the secondary and then failover to secondary (no configuration changes are seen when compared)But due to this NAT behavior change I had to failover back to the primary which still runs 9.1(2).B...
