Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Two of my controller suffer from a kernel panic when booting up (see screens attached) .Can you please advise how do I reinstall it? I have DVD with the latest software already burned and ready to go.Is it as simple as installing new linux softwa...
Hi, I'm running a cluster of 3 APICs with version 1.0(1e). After initial provisioning process using the console port on the back of the APIC servers, all runs well. I have access to HTTPS, SSH etc, but I lost console access to APIC servers. Is that a...
Hi, I'm using a standard Cisco console cable when connecting to the APIC console port and all three are not responding. I will try to install the new APIC software and retry it. I will keep you updated. Regards,M
1. From my proposing solution, is it valid to deploy?I would recommend o keep it simple and deploy s single fabric (2xSpine, 2xLeaf 1x cluster) per DC. 2. Do I need L2 Extension between both 2 DCs, if yes, what is the prefer technology (OTV, EoMPLS, ...
Tip:I used USB stick to upload the ACI image and EPLD image to the switch. Question:Why do I need to upload and configure mentioned certs? I built my fabric without uploading certs and running prepare-mfg.sh as the switch formatted itself while boot...
