Hi, do you somebody know, how I can monitor FTD all CPU load? I know, that FTD has 2 level CPU (LINA and SNORT). I need monitor CPU load HW appliance. If snort is high load, this not mean, that FW is overloaded. Thank you for your advise.Tomas
Yes, it's correct. You can't see new version FTD in FMC. But You can verify in LINA (ASA). New hotfix upgrade only ASA code. After upgrade, you can see ASA version 9.8(2)135
Tomas
OK, but in system, I can't see new version (I see still version 6.2.2.1) :(
If I try install hotfix again, FMC show me same Firepower appliances. In FMC see old version FTD.
Did you open TAC for this issue?
T.
Hi, I don't think, that this is good feature for backup ASA config. If I send configuration export full, in email (from ASA) I can't see ip address ASA, username, ip address tunnel-group and etc :( For example:tunnel-group <IP removed> type ipsec-l2l...