Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am trying to debug an issue that is causing our traffic to stop flowing through our firewall (ASA 5512-X) to the outside. Here is the history thus far...about a month ago our network would fail...first weekly, now every couple of hours. The...
I have reviewed numerous support discussions on this particular issue, but I am still unable to properly configure my ASA 5512-X to receive SMTP email. I can send email, and have access to all other services that I setup. I did create a network obje...
Last night I removed the ASA 5512-X and replaced it with my old SA520...I am noticing the same failures with the exception that the SA520 comes back up within a minute or two compared to several hours with the ASA 5512.
I put a call into Frontier Co...
Thank you for the response...
I don't actually have an SSD installed...I believe there is a boot disk, but I think that is internal to the unit.
I forgot to mention one other important detail...when the flow of traffic outbound stops, it does resume ...
Thanks Vibhor and Murali,The problem has been resolved!As I did my research into this issue, I saw numerous posting about ensuring the proper order for NAT...I made a bad assumption that the NAT rule for a network object was treated independent of a ...
Hi Murali,I ran the packet tracer routine...please let me know if I did this correctly...the results are below. The results indicate the traffic is denied by the implicit rule, but I'm not sure why.... ciscoasa(config)# packet-tracer input verizon t...
Hi Murali,My apologies...I probably should have provided the ACL I used for the uploads:For the first upload I used (file ASA_CAP-2.txt):access-list asa_cap extended permit tcp any4 any4 eq smtpcap asa_cap interface verizon access-list asa_capThis ap...
