Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!We have a problem with two ACE20 modules installed in Cisco 6509 switches and working in fault tolerance mode.Both nodes continue working and doing LB, but it's not possible to configure it, show config, change context, et cetera.Looks like some p...
Hello, world!We have weird behaviour of our Cisco ACE20 module configured for end-to-end SSL (initiation+termination) - the module from time to time replies with SSLv3/TLSv1 alert "Fatal: internal error" message to the client right after client have ...
Hi Kanwal,Thanks a lot, it's good to know we should allocate dedicated resources for management! Maybe it's the root of the problem. Maybe not. We'll do it after resetting modules anyway. And on the second ACE (active for all context, the previous on...
Hi Kanwal,Thanks for your reply, but it doesn't work. I can't even see resource usage:ACE1/Admin# sh resource usageError: Transport errorMaybe after I reset the ACE I'll see something, but as I mentioned in previous message, ACE works relatively long...
Hello everybody!At first I would like to thank all of you guys who participated in the discussion and tried to help me with my problem! Thanks for your time guys!The problem has been solved be reload of Cisco ACE module, now it works fine. The proble...
Hello Christopher,I noted this behavior with both 443 both in end-to-end SSL and SSL termination modes.End-to-end SSL: Server (443)---SSL----ACE(443)---SSL---ClientSSL termination: Server(443)---unencrypted---ACE(443)----SSL---ClientIn SSL terminatio...
Hello Jorge,I balance both 80 and 443 but SSL termination is only on 443. Again, with pure L4 load balancing (without SSL-termination) ACE works fine. Directly from client to servers there's no problem with SSL either.I see this behavior really often...
