I used to see this fallback to 192.168.0.10 process when I worked with Volo/Endo units.  Our work around was to set the radio to offline mode and then after it cycled configure the radio the way we wanted.  We would weird interactions in the field wh...

Did you make sure to pick your management interface with the following command (config)#wireless management interface vlan <your vlan here>I got ahead of myself during an install and without that command the cert won't generate, also make sure your m...

I wanted to add some feedback and I haven't seen anyone talk about KVM so far.  I was able to get things running using the recommended Ubuntu 16.04 LTS build.  I ran into a ton of Linux bridging problems but once I was able to get an IP on the box th...

We have about 120 access points shattered across the country and I have them setup to talk to a pair of 5508s we have in our data centers.  I configured primary and secondaries to load balence them by site.  I am using FlexConnect running local switc...

I have a similar issue with two 5508s setup in a similar way but the APs are in Flex mode running on 7.3 code - Should I bring the two WLC into the same mobility group?  I built the WLC as stand alone pairs when I started getting into the Cisco Wirel...