Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
IntroductionConfiguration IntroductionThis document provides a sample configuration for changing the external interface IP address on ASA. Configuration To change the external ip address, we need to go to the external interface, and enter the new ip...
Hi,This is a known issue caused with the change in certificate at Trend Micro used to sign pattern files. Please find the documentation below :https://supportforums.cisco.com/docs/DOC-40231This issue is addressed by CSC Module patch 1140 for version...
Hi Gangadhar,It is normal to see the promiscuous interfaces go up and down. Another scenario is during configuration changes. When signature updates are installed, configuration changes made, or when signature tunings are performed, it is expected to...
Hi ,It seems like the mainApp has hung on the IPS.Two known defects which might cause the same : CSCtj86988 and CSCuf20148. However, CidDump and few other debugging outputs are required to investigate this further and would give us a better insight o...
Hi Gabriel,Please find the steps below to enable email notification through IME :http://tools.cisco.com/squish/B9497Hope that answers your query.Thulasi Shankar
Hi ,Please execute a "session ips" from the ASA to access the sensor module. Post this, you may execute "Show config" on the sensor to verify the configuration. The default username/password on the sensor module is cisco/cisco. IPS run as a licensed ...
