Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi There,I have an SRP547W running the firmware version: 1.2.6 (003) which I believe to be the latest according to the Cisco website.Does anyone know what heppened to the jumbo frames setting? Its just gone. I even reset the router to factory defau...
Hi All, this is my first post so I appologise if I have posted it in the wrong place up front.I have recently purchased an SRP 547w replacing an 877w and linksys pap2t voip box.I have 1 major issue at present - no matter which number I dial, I cannot...
So here is the latest on this oneIf you roll back to the earlier firmwares, the jumbo frames are there and accounted for so its definitely a firmware issueGot a call logged with Cisco.This device is end of life so the fact that their firmware no long...
Hi Marty,So I rolled back to code version 1.2.4 from 1.2.6 and found that jumbo frames reappeared. Cisco has omitted them for some reason - my guess is they forgot otherwise they would have updated release notes to suggest. In either case, I've att...
Hi Marty,Thanks for your prompt response.I've tried IE and Chrome with the same outcome. I enabled compatibility mode for the SRP and still the same outcome unfortunately.I've also confirmed that I am logged in as admin.I've tried another completly ...
