Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,On our ASA 5520 I have the following config:interface GigabitEthernet0/0 nameif outside security-level 0 ip address 218.257.136.133 255.255.255.224 standby 218.257.136.134!interface GigabitEthernet0/1 nameif inside security-level 100 ip address...
If I do show context I get the following:Haddad/2# sho contextContext Name Class Interfaces URL 2 default GigabitEthernet0/0, disk0:/context2.cfg GigabitEthernet0/1, ...
I get this:Haddad/2# sho run prompt ^ERROR: % Invalid input detected at '^' marker. Haddad/2# sho run prompt ^ERROR: % Invalid input detected at '^' marker.
Hi,Thank you for the reply.I cannot change the context to system - it does not allow meHaddad/2# changeto systemCommand not valid in current execution spaceHaddad/2#Any suggestions here? Thanks in advance
