Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
due to CVE-2016-1287 we are forced to update our 5550's from 9.1.1 to 9.1.7.
The 5550's are running in active-standby-failover.
Fortunately we have a pair of them for test-purposes.
Steps i took:
1. Copied Image 9.1.2 to both nodes
2. Set boo...
Hello,i ran into some problems while implementing DynamicPolicyNat on our Asa 5550.Goal is to enable filetransfer for clients on our inside network to some servers on our outside network.So i set up following config:object service SFTP service tcp so...
Update: Just reproduced the procedure with a laptop connected to console-port.
After reloading the second unit from standby-mode it wasn't detecting the other unit as active-mate!
Then the normal behaviour began, the just reloaded unit was syncing it...
Hello,
no, seems that the unit has not chrashed, "show crashinfo" is empty.
Problem, is not only related to 9.1.7, it happened on our side also during the upgrade from 9.1.1 to 9.1.2, so seems that the problem is another one!?
Regards Uwe
Hello,yes, you understood right, that's exactly my situation!Thanks a lot for the Bug, so it seems the be a prob on the Asa itself and not in my mind! "Of if your situation permits that this NAT can be done between these internal and external hosts...
Hello,we need these nat-rules as our outside-network consists of several subnets and these subnets don't know about the inside-network, so we are solving the routing prob with it. But some hosts on the outside are located in the subnet directly conne...
