Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey all,This is the situation:(the shown ip adresses are fictional)We have a server with the internal IP Adress of 10.1.100.2. Our public Adres is 214.214.214.214. We also have a public adress of 214.214.214.215.This server needs to send traffic over...
Hey all, Im hoping anyone can help me because i cant seem to figure it out. I managed to create an site to site vpn between location a an b.I will be using fictional wan adresses. SiteA 20.20.20.20SiteB 21.21.21.21 Site B is a very simple netwerk. We...
Dear Cisco Experts :),We have a wireless network for our guests. This network uses the firewall (an asa 5510) as gateway. Now we are looking for a way to log the following informationMac Address or IP client - Time/Date - Information (Url/ip/protoco...
Hello guys,Im hoping yall can help me with the following objective. I have been tasked to make a site to site VPN between two networks. We are both using an ASA 5510.This is the scenario:SiteA has an wan adress of (example) 20.20.20.20 - The firewal...
Well i did make a static nat rule (using the gui)I did a packet trace and it says 10.1.100.2/8555 translate to 214.214.214.215/8555 so i guess the problem doesnt lie on my end. i will call them tomorrow. (Btw i tryed the nat (inside,outside) command ...
Well it works. Apperiantly i was to impatient.....) as i didnt really change anything. This morning i turned my firewall on and tryed again and at first it didnt work but after a minute or 5 i was able to get through. Thanks for youre quick response
Dear Jouni,We are running version 8.4(2) (adsm 6.4(5))I have seen their network briefly and they havent done any subnetting. They do use some kind of logic when giving out adresses but nothing has been done to seperate these ranges. (for the devices ...
