Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,After configuring FCoE, we are getting "Trunk vsans (initializing) (VSAN NO.)". We have followed the below steps:-1. "switchport mode trunk" for physical port where FCoE cable connected.2. spanning-tree port type edge trunk 3. Al...
Hi Ganesh and All,I have checked with Cisco Engineer. All configurations are fine. From Server side, we enable FCoE in BIOS level and it worked fine. Thanks to all.
Hello Luke,I have attached the output of below commands. Could you please confirm whether QoS is enabled or not? I am not expert in Network. No idea about this. ThanksXXXXXXXX# show policy-map Type qos policy-maps ==================== policy-map...
Hi All,For the other Switch, i am getting below error.PDCNX02# show interface vfc 542vfc542 is trunking (Not all VSANs UP on the trunk) Bound interface is Ethernet1/13 Hardware is Ethernet Port WWN is 22:1d:00:05:73:d3:9a:bf Admin port m...
