Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts,I've been trying to get my IPS Sensor which is running on my ASA 5512X, every time I try to get the Sensor to get time from my NTP server, it fails with an error message "errUnacceptableValue - Cannot connect to NTP server or NTP server is...
Sorry, I don't understand. If I remove the management IP address, how do I then control the IPS sensor? It didn't seem to let me use the inside network.
Hi Arsen,Thanks for your input with this. I have to say, this is getting ridiculous, I don't understand why the time between the IPS and ASA just won't sync. For the ASA 5512X there is no hardware module, just software.I couldn't add the static route...
When setting up the sensor, it would not let me use the network which was already set up for the inside network. I had to use the management interface to gain access to sensor, but I can't get the sensor to be on the same network as the inside.
The ip address on the management interface for the sensor is 192.168.100.99. This network is isolated and is not connected to any other network including the inside network.
