Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a Cisco ASA 5510 and would like to setup a NAT rule for one server but only for traffic that matches a destination with a specific IP and Port. Is this possible? The reason I ask is because I have one application that requires a connect...
Hi There,I am looking to setup a Cisco ASA 5510 with 2 outside networks and 2 inside networks. I would like it setup so that Inside1 will only use the Outside1 connection and Inside2 will only use the Outside2 connection. There will be absolutely no ...
Thank you! We are running 8.4.Basically what I am trying to achieve is this:Internal Server (192.168.1.22) creates a session with external server (111.222.111.222) on ports TCP 333 and TCP 444. To access the external server a VPN is established, howe...
Ok, yes you guys are right. I didn't really think about the "Destination". Both Inside networks will be attempting to access the same Destinations and therefore will probably end up going out through the one Outside interface which I cannot have.So i...
