Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,Just wondering if I can ask an opinion. We have recently setup a Cisco ACE 4710 in routed mode in order to load balance between our client traffic from the internet and our webservers inside.The requirement was to set up the ACE to load bala...
Sorry if this may come across as a stupid question as I am quite new to the Cisco ACE 4710. I have configured a Cisco ACE 4710 and it is working perfectly fine, and load balancing between 3 different servers to host our e-commerce website; but at the...
Hi Gaurav,Thank you very much for your reply.With regards to the NAT confguration, do you think it matter that I only have 1 address allocated in the NAT pool (192.168.100.254), in terms of concurrency of many clients, and/or resource usage etc? Also...
Using this method all client requests arrive to the webservers as the nat 192.168.100.254 allocated on vlan 101; is there anyway for the real servers to be passed on the client IP addresses?
That worked beautifully, just added the lines as suggested above, and life is good again!Thank you very much for that, great to talk to a professional...Best regards.
