Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have setup a site to site VPN between Cisco asa5510 and Sonicwall tz200, the tunnel established successfully, but there is no traffice crossing tunnel. everythi is ok on the Sonicwall side, but asa is somehow blocking all the inbound a...
Could this NAT policy be the reason?access-list Inside_nat0_outbound extended permit ip 192.168.0.0 255.255.0.0 17216.149.0 255.255.255.0192.168.0.0/16 is the local subnet 172.16.149.0/24 is the remote subnet
I'm pretty sure that this is a routing issue, since ASA is receiving the packet, and dropping it since it does not know where to return it to:There is no route to the VPN tunnel in here:asa# show run routeroute Inside 172.16.21.0 255.255.255.0 192.16...
Hi Julio,Everything seems to be ok in this access list. I think this is a routing issue. It is just does not know where to send the packet back or where to reply.Crypto map tag: XXXX_map, seq num: 7, local addr: x.x.x.x access-list XXXX_7_cryptomap...
