In the below output what exactly is "path-id"
RP/0/RSP0/CPU0:ASR9006-P2#sh ospf vrf TR-VRF-1-1 routes
Wed Jul 3 07:26:38.194 UTC
Topology Table for ospf 8, VRF TR-VRF-1-1 with ID 100.0.1.2
Codes: O - Intra area, O IA - Inter area
...
Hello, NAT works only on the traffic and not on the BGP routes. To advertise the NATed routes in to the BGP, configure a static route towards null 0 and advertise it to the BGP using network commandI have somewhat understood your requirement Could y...
Hello, To isolate the issue, we could follow the below steps. 1. remove the IPSec config from the tunnel and ping tunnel destination IP taking tunnel source as source IP a. If there are any drops, trace the tunnel destination IP taking tunnel sour...
Hello Raymond, This works perfectly well. Please refer the below link for configuring EIGRP on nexus 7k http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nx-os/unicast/configuration/guide/l3_cli_nxos/l3_eigrp.html Let me know if you are...