Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Please can someone assist me with this quite basic configuration? (forgive the simple question but I am not too familiar with ASAs)I need to configure an ASA 5505 to allow access from the inside interface to hosts on the DMZ interface (for SSH)My par...
First of all I am very sorry for the delay.In addition to:global (dmz) 1 interfaceThis is what I configured:static (dmz,inside) tcp 10.10.1.100 ssh 10.10.1.100 ssh netmask 255.255.255. 255access-list in...
Hi Jumora,Your advice seems sound and I apologise for the delay in replying - it's because since Thursday I have been in London dealing with a problem with, ironically, another Cisco ASA.I have access to the ASA that is the subject of this problem an...
Hi Karsten,I now have access to the ASA so can respond more easily. Meanwhile, here is the result of the show commands that you requested:ASA# show run natnat (inside) 0 access-list inside_nat0_outboundnat (inside) 1 0.0.0.0 0.0.0.0nat (outside) 0 a...
Thank you very much Karsten - I have asked my counterpart in the country where the firewall is to provide this command output. I have also asked him to configure the NAT statement. What you have said makes sense and I have relayed the information. ...
