Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,I currently have an RV042G with a downstream SG-300 connected to one of the LAN interfaces. Connected to the SG-300 are a couple servers running ESXi. Intervlan routing is working fine on the current setup; however, I only able to co...
After doing some research, I found this in the admin guide for the RV042G:---Typically, a Cisco RV0xx Series router is used as an access router, with a single LAN subnet. By default, the firewall is pre-configured to deny LAN access if the source IP ...
I guess I should clarify, the SG-300 is running in Layer 3 mode, and the VLANs are defined on it; however, the static routes are defined on the RV042. Maybe there's a more efficient way of doing this? Below is a scrubbed copy of my switch configura...
