Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am testing ASA 5550 to allow inside servers outside access through static NAT. I have done reading Cisco's documentation about how to set it up.my test network:OUTSIDE ROUTER (2811) ----------(OUTSIDE) ASA 5550 (INSIDE)(OSPF)-----------INSIDE ROUTE...
Hi everyone,I wanted to create a static NAT by following Cisco's documentation for ASA 9.1 firmware. Inside network is using PAT without any issues but ASA is not doing NAT for some internal servers from outside. I tried to troubleshoot but I have n...
Hi,I've found out after checking with packet tracer, it looks like inbound connection is failing because of rpf-check. how can I make sure that return traffic from servers follow back their original NAT connection?John
Hi Maykol,If I use Cisco 2911 to do NAT in production, I have not problem with inbound or outbound traffic. But as soon as I replace the router with ASA 5550 (using the above config), device does not allow inbound traffic even though I allow pretty m...
Hi,yes my internal servers are reachable, I do not have any other firewall on the servers blocking those ports. I do not think I have any routing or firewall problem. I do not know what I am missing.ThanksJohn
Hi Jouni,yes there is a static route (it is deleted from the config posted by accident) pointing to the outside interface.Problem is with all of Static NAT entries. I do not have any issues with any internal routing and I can easily ping my outside g...
