Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
New to ASA Firewall. Trying to setup a home lab following a Microsoft guide. I have one network that is using AT&T ARRIS NVG599 and I have my home lab network using a Dell server with VMWARE installed that has 2 NIC cards, one NIC card goes to the ...
Hello, need help in deleting static route to outside interface. New to ASA, I picked up a asa firewall for a home lab and it is behind a ARRIS NVG599. I have set my outside interface to obtain an IP Address from DCHP on network 192.168.1.0. I h...
Thank you for replying. To answer your question, Are you trying to convert your internal IP to one of those IPs, the answer is yes. Also, are you saying that I need to create a route from the 10.10.1.0 network to the 10.0.0.0 network. If yes, woul...
Sorry for the confusion. I was trying to ask how to correctly configure a asa 5510 firewall behind a AT&T ARRIS .My lab will be routed through the ASA 5510 and I would like it to be able to reach the internet. Looking at your answer it appears that I...
Thank you, that seems to have worked. Thank you so muchAnother question any Ideas of how to NAT behind an ARRISNVG599. I tried using the example below but it did not work. Also, I cannot ping from the 10. network to a 192. network.The following examp...
Thank you, that seems to have worked. Thank you so much Another question any Ideas of how to NAT behind an ARRIS NVG599. I tried using the example below but it did not work. Also, I cannot ping from the 10. network to a 192. network. The followi...
