Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I haven't had much luck on responses to this however here goes. I have an IPSEC VPN tunnel up and connected. I can ping a remote IP address from a local address however I cannot Telnet to Port 55019 of the same remote IP Address. It seems that...
Hi, I have an issue where I am sending a Telnet request to a distant server on port 55019 however I get the following response on the ASA5506 log Teardown TCP connection 446446 for outside:Public IP/55019 to inside:192.168.1.10/2639 duration 0:00:3...
Hi, We have a VPN Tunnel that has been created between a CISCO ASA 5506 and a Huawei Security Device, the tunnel is up and running but I cannnot seem to communicate from the Inside Lan to the remote Inside Lan, .i.e. from 192.168.1.10 to an externa...
I have cleaned it up as follows -nat (inside,outside) source static WEB_Server interface service any WEBRDPnat (inside,outside) source static WEB_Server interface service any FTPnat (inside,outside) source static WEB_Server interface service any HTTP...
Result of the command: "sh run nat"nat (inside,outside) source static PET_WB PET_WB destination static SMSCSMSC no-proxy-arp route-lookupnat (inside,outside) source static WEB_Server interface service any WEBRDPnat (inside,outside) source static WEB_...
