Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Yes, I know this is idiotic, but I'm not finding it in my book. Please don't flame me...IDS 4215, I'm in the command line and have enabled an additional sensing port. It's working fine - how do I save the config change? wr mem is not so much worki...
I installed the patch successfully, but am unable to get past 4.1(5)S189. It does nothing - I've checked disk space and rebooted the sensor but it just won't take and now I'm going to try the latest and greatest sigs, but I'm pretty certain that tho...
I have a PIX 515-E w/ver. 6.2(2) (asking for a new one for x-mas) - the configuration I inherited included statics and conduits. Yes, I know I'm supposed to convert these to ACL's but unfortunately, I can't get the ok for the down time.Meanwhile, we...
I'm attempting to connect Client ver 4.0.3 (c) to a 3000 concentrator using a sierra wireless air card 750. It negotiates and gives me my welcome banner, but once I'm in, I can't do ANYTHING or ping anything.I've tested this configuration over a bro...
Sorry about the delay in responding...The 4.1(5) completed absolutely perfectly - no notifications, smooth as glass. Which is why I don't understand why subsequent signature updates aren't going in.Since I'm not exactly getting a plethora of respons...
I'm experiencing the same problem. If I don't use the wireless modem - say for instance, use DSL, I can use the client successfully - so I know it's configured properly, but when I try to use the wireless modem, once the tunnel is built I can't do a...
