About stfelix

stfelix · 12-03-2004

Hi! On C6K with CatOS, IDS Loadbalancing is possible if it uses EtherChannel and VACL Capture. Is Possible on C6K with Native IOS? Which version is possible and Where I find that solution. This is the sample configuration that uses EtherChannel and V...

stfelix · 06-09-2005

How about upgrading for V3K Image? Re-try after upgrading from 4.1.4 to 4.7. Thanks.

stfelix · 12-06-2004

Hi.marcabal, Thanks for your helpful reply. We had the problem which we do not have a reserved slot to remain.So, we had started this conversation. Again, thanks for your helpful reply.Thanks.

stfelix · 12-04-2004

And also I could configure as below on Native IOSThis IOS version is 12.1(22)E2. 1.Configure the EtherChannel between the 6500 and the sensors.interface Port-channel100 switchport!interface GigabitEthernet3/3 switchport channel-group 100 mode on!inte...

stfelix · 12-03-2004

OK.. I see.So, Isn't it that can solve this environment?The condition to be desired currently is like the this.1. The bandwidth to be desired is up to 5GBps.2. It is bi-directional traffic.3. and We have to analysis bi-directional traffic4. Cisco IDS...

Member Since	‎12-09-2003 02:29 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	5

User Statistics

User Activity

How to IDS LB on Catalyst 6500 with Native IOS

Re: C3030 WebVPN and IE 6.0 WinXP SP2 problem

Re: How to IDS LB on Catalyst 6500 with Native IOS

Re: How to IDS LB on Catalyst 6500 with Native IOS

Re: How to IDS LB on Catalyst 6500 with Native IOS