Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm currently having some problems getting a VRRP failover config to work. Basically,i've got three VLAN's, each of which has the same critical service for their respective VRIDs. This critical service only monitors the internal switch to which the C...
We figured it out. The switches were also reachable through the exernal network. Consequently, the internal VRID was going slave, and the external ones where telling to go master again... solved by adding a route to blackhole...
please see below for the redundancy config.. sorry, i masked the ip addresses partly because these might be sensitive.. i can mail you the complete config...Status after failover of the critical service is flipping (recalling from memory now) from al...
