Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,
the current deployment i have is the NGFW which is in routed mode so i can use as gateway for all inside subnets. it connects to the ISR router before its connect to the public internet (connection between NGFW and ISR router still private networ...
Hi, need help on my CME-PABX that's connect to the external SIP server for external calls. The external SIP server is pointing to public ip (202.x.x.1) as per diagram below. I need to map this to our CME (10.10.130.1) in order to reach the external S...
Hi, I'm trying to test the connectivity on my current network setup on the FPP1120 device. But cannot make a successful ping from outside to inside host (inside to outside is working fine). I'm just wondering if ICMP is blocked by default from outsid...
Thanks for your inputs @MHM Cisco World
Can you just confirm that I can still retain this below NAT overload for my internet access?
ip nat inside source list 10 interface GigabitEthernet0/0/0 overload
Just to summarize my issue above, I just need to configure ISR4321 to translate public IP 202.x.x.1 to the private IP in the inside which is CME 1010.130.1. Meaning public IP 202.x.x.1 should be able to translate to 10.10.130.1 which will use for SIP...
