Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we recently purchased a RV340 dual WAN router.In order to check the status we need to collect data using SNMP.After the first setup we was able to get data from SNMP, except for Interfaces (the only data that we need to collect...).After upgradin...
Hi,I'm using Paessler's PRTG for traffic monitoring, but, despite having several sensors dedicated to Cisco routers, they did not work with the RV340 (it seems it's not a Cisco IOS based device), After long search and testing I've found this:WAN1 rx ...
Hi, I have found a solution. The problem was my fault.The story:1. unboxed2. configured3. tried SNMP (working well)4. updated with the last firmware (v1.0.01.17)5. tried SNMP (not working at all)Unfortunately I did not read the Release Notes for the ...
Matthew, do You know a serious replacement box for the RV320?I need a dual WAN Router/Firewall (for backup and active/active scenarios). ASA 5506-X is a Firewall and is not designed to support load-balancing (but You can set static routes...). The qu...
As I saw (when unboxed the device, without any Firmware upgrade and SNMP worked for a while) the device is Linux based, instead of Cisco IOS.Cheap devices with many problems?Not so good for a brand like this...
Hi,I purchased a RV340 and I experienced some of Your problems.First of all the SNMP service: there seems to be no way to make it work.Have You received any suggestion or tip in order to make it work? Regards,EDL
