Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Reimaging 5508-x because No enable Command and I'm hoping someone has gone through it once or twice and can give me a heads up on any possible pitfalls or odds and ends I need to note ahead of time. Using the process layed out in Reimage the Cisco A...
I got a new 5508-x at work. Out of the box went through the defaults via wizard, changing the internal and management ip (already in use somewhere else). Rebooted as instructed, everything looked good. The prompt I get is a > symbol but I'm not in...
If for some reason you end up like me and something isnt quite right with you new ASA 5508-x with FTD and you need to get back to the begininning. I finally found some help and answers on the very bottom under "Uncommon Management Tasks". Then there...
I have dropped into lina with no more control than before. I was watching a reboot of the system and it did have link lights. I opened to connection in MS and I was only getting data sent the was no data recieved. Once the ASA was up the lights we...
LOL....if you only knew how many times I've heard..."thats odd...". yeah in the running config the interfaces are all shutdown and no ips. The output of "show network" has an IPv4 Default route gateway ip, br1 has no ip, IPv4 has been manually confi...
