Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Afternoon, We are looking at deploying FTD's and the it has been brought up that new policies are to be built as well. The concern is that deploying these new policies in a monitoring state to ensure it does not block valid traffic will lea...
The Manual Deployment of firepower recommendations persistently is timing out. I have attempted to push out the recommendations after generating them to no avail. the system will appear that it is deploying them to the devices, but after about 20 min...
***ERROR*** Error starting eStreamer source xxxxxx eStreamer: SSL authentication failed - closing the connection: A call to SSPI failed, see inner exception.
I am receiving this error on a SIEM when attempting to send logs from the estreamer to SIE...
I have generated the Firepower recommendations but when I attempt to push them out to the devices, it stays in a state of initializing then just quits after about 30 minutes. has anyone else had this experience. I have never had this happen in previo...
We have been experiencing periods where the FMC states that it is experiencing high CPU usage. I ran the "top" command it get the output included in the Snapshot taken. it also states that the time is out of sync but when I look at the config it, it ...
Did you just configure the FTD to send the VPN syslog over to Splunk? I am in the same boat and trying to decide if i need to do this to see logon/logoffs. did you forward them to a syslog server then on to the indexers of splunk? Any tips or tricks...
Right, I believe that is correct. The issue is that this works fine on the other FMC going to LR. Its this one particular FMC and LR instance that is refusing to cooperate. any insight is very much appreciated. thanks!
