Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working on an ASA5509 for a customer of ours and we are trying to open ports to LDAP to an outside service. As far as I can tell, the NAT rules and access-list are setup correctly. When I run packet tracer everything comes back fine and I am see...
This made no change. And now again, we have a rule in place to allow 25 out from our internal mail server and for some reason this is now not working. There are too many weird things going on with this ASA.
sh nat
Manual NAT Policies (Section 3) 1 (inside) to (outside) source dynamic any interface translate_hits = 106601, untranslate_hits = 28479
sh run access-list outside-in
asa5510# sh run access-list outside-in
access-list outside-in extended...
Yeah, that's a typo sorry I know that's a big oversight. The odd things is that we have 2 other 1:1 NAT setup and one is working fine and the other now isn't working. (one was for email port 25 and the other https, the https is no longer working).
