Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I had built a web-based app to allow our network admins more easily administer our PIX, which used the conf net command to suck down configuration changes from a tftp server. After upgrading our PIX's software from 5.2.3 to 5.2.8, it doesn't appear ...
Hi all, this is the second day of our PIX's use as a VPN gateway. Until last night around 11:30, all was well, but since then, we get varying error messages on win2k clients (that's all we're using). Today, I inspected the syslog files and noticed ...
I have configured a syslog server for my PIX 515 and am recording warning-level and higher messages (really simple setup, too). I notice that the port number is not supplied as information in any of the logging lines. Is there a way to have the PIX...
I have a pix 515 with 6 interfaces (three of which are currently used). The second and third interfaces use private addresses in the 192.168.1/24 and 192.168.0/24 address ranges. The servers behind the third interface have their IP's statically map...
I have the same problem. It's not very handy to see warnings in the syslog without knowing what port those denied packets were being sent to/from. Can a moderator/expert shed some light on this?
This is the same text as in the Configuration Guide, which I guess I'll read through again...I must be overlooking something. (DNS servers are on intf2 (Production) and machines requiring resolution are on intf1 (inside), so I'll have to scrutinize m...
