Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to find cabling intructions for my new 11503. I don't know how to cable between the 11503 and the switch the web servers are in. I also don't understand the relationship between the VLANs on the 11503 and the switch.
I am unable to browse to a virtual server from a real server. Any other computer on the network can browse to the virtual server. The LocalDirector and all real servers being balanced by it are plugged into a vlan that seperates them from the rest ...
Thanks again - you mentioned that the CSS will 'bridge' between the interesting traffic. One problem we had with the LocalDirector was that real servers from one web farm were unable to browse to a different virtual server behind the same LocalDirec...
Thanks - I tried implementing the GB trunk and now I have a different problem. I trunked the GB interface to two VLANs. Then I created two circuit VLANS (same vlan numbers as I used in the trunk) and applied an IP address to each. The second IP ad...
So I create vlans on the switch (for each web farm)and bridge CSS interfaces to the switch vlans? I was hoping to use a CSS GB interface (1/1) to uplink to the switch. Do I do that by bridging and trunking it to all switch VLANs?
I looked into what we need here a little more. Not all sites need to see each other. I am going to try to seperate the sites that need to see each other by putting them into seperate VLANs.
