Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am very new to using Trex and have a question regarding configuration for IPv6 stateful testing. First of all, I want to say Trex is an amazing tool. It has been perfect for the testing I'm performing. Thanks for all of the hard work creating it...
Thanks...I guess my Google-fu failed me when searching for the correct forum. I'll use that in the future if I run into any other issues. So far so good!
Ah, so it turns out the captures I did in my last reply weren't correct. I had a left over source-interface statement in the monitor configuration which caused me to see both sides of the traffic instead of just the traffic sourced from NIC0. Remov...
I tried the original cap2/sfr_agg_tcp14_udp11_http200msec_new_high_new_nir_profile_ipg_mix.yaml config without the '-e' option and still saw the mixing of source prefixes coming from NIC0:753 0.038209464 2607:fe50:0:f802::1006:32d3 -> 2607:fe50:0:f80...
