Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Primary PIX and Secondary PIX are plugged into the same 3524 switch. Vendor routers are plugged into the same 3524 switch. RIP is exchange between vendors and the PIX. When we unplug a vendor router (Not PIX interface) from the 3524 switch, Primar...
I issued the show failover command on my primary pix box. It showed two of the three interfaces in normal mode, but the third ( a vpn tunnel) was in test mode. I was able to ping, and send traffic successfully going through the third interface; but ...
Thanks. I found the following that fits my issue:When RIP2 is enabled on the inside interface the PIX inside will looseconnectivity and failover. Even when failed over to the secondary the sameinside IP is not pingable. Debug RIP on the pix shows no ...
