Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a FPR1010-ASA-K9 which I bought new for my home office to replace a trusty old ASA5505 which served me for many years and I only decided to upgrade as I could finally get more then 100Mb/s internet. Since I have had this device it has a...
As a point of reference...No assited cooling, in a 20 degree Celsius roomProcessors: -------------------------------- Processor 1: 75.0 C - OK (CPU Temperature) Chassis: -------------------------------- Ambient 1: 60.0 C - Warm (Inlet Temp...
Hi Everyone,Aologies for not responding I have had a few busy days.M - I found the buttons you referred to eventually however I believe the FPR rebooted via hardware so it didnt capture any logs at all, CLI tool gave it a clean bill of health apart f...
Hi Marius,Without Smartnet on this device I cant get software downloads for it, I have 50+ other devices on Smartnet just not one one these. It shipped with 9.13.1 and seeing Cisco wouldnt assist me any further I did manage to get them to give me lin...
Hi JitendraThats an interesting link and it does show high temp readings for both CPU and Chassis, here is a "sh env" as it sits here doing pretty nothing right now. I dont understand what the "Ambient" actually means as its obviously not room temper...
Thanks for the quick response M.I wasnt aware of this tool and dumped the "sh tech" into it and it does report an issue with the environment as per below, I suppose the question what exactly is the temp referring to as its certianly not the room I am...
