Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I want to create an active/standby failover set-up for an existing production multicontext FW. I do the usual failover configuration, replication ends, so far so good, but after 5 minutes the secondary/stanby unit gets stuck in the bulk sync...
Thank you for the quick reply !
What you are saying is true, but was not neccessary in this case.
For some reason after about 3 hours of staying in bulk sync state it is now looking fine, have to say I have never seen it do something like this....
