Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I am using a PIX 515E with two interfaces and can't get out from the inside to the outside interface. I don't need or want NAT. The network is configured as follows...router <---> pix <----> switchWithout the PIX the router's address is 1...
We currently are using a CISCO 905 cable modem router for Internet access as well as access to our coperate WAN. I am trying to add a CISCO PIX 515E firewall without much success. We are already using NAT on the 905 router so I don't want to use it...
Bryan,I have a few more questions :-). 1. You seem to know what your talking about when you say not to use NAT 0, but I was wondering if you could enlighten me as to the reasons for that.2. By not using NAT on the PIX does the PIX then become a tran...
Bryan,Thanks, I haven't tried your suggestions yet, but I'm sure the 3rd suggestion is one of the problems. I forgot to add the route back after changing the IP address on the router. Thanks again.Warren
