Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Running the command sh sticky-table l3-sticky, the entry still show after the inactivity timeout. Shouldn't the entry remove after no activity for the configured sticky-inact-timeout 10. How do I test stickineness.
When a service (TCP) is down, the client requesting via VIP does not detect the service is down on the server till abt 25 sec later.If bypassing the CSS, the client requesting the service directly on the server detect the service is down almost immed...
When all the load balanced service is down, VIP is not able to ping.The VIP thus not able to reply the TCP sync ack session request by the client.The flow-reset-reject seems does not resolve the delay.Is there any command to enable VIP to be pingable...
Below are the configuration service LD23_Test ip address 10.80.20.139 keepalive type tcp protocol tcp keepalive frequency 10 keepalive retryperiod 2 keepalive maxfailure 1 keepalive port 8101service LD24_Test ip address 10.80.20.140 keepaliv...
