Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello ALL,Need suggestion!!!!
My Goal-Communication between R3 loopback interface and R1 using site to site VPN.Everything is working fine but i have a doubt.
Below is configuration provide.
I have ACL created on PIX and on R3.
***PIX***access-list 1...
Hello All,
I have one query on ASA while working on GNS3.
1.I am successfully able to deny the telnet traffic from inside to outside using ACL by placing it on IN direction of INSIDE interface of ASA.2.But not able to allow ICMP from inside to outsid...
Richard, Yes indeed my topology is working fine.R1>>>>PIX<<<<<ISP(R2)<<<<<R3 (Lo0)In originally post i put ACL from R1 to R3 (lo0) direction on PIX and it is working fine.Then in previous post i changed my ACL direction from R3(lo0) to R1 and communi...
Hello Richard,1.As you can see i am explicitly allowing traffic from outside to inside using ACL. So why it is not working?2.I normal scenario that is how we allow traffic from outside to inside ,right?3.Is there a exception when we use VPN? access-l...
Hello Richard,Thank you very much I got your point.I have one more query I tried to put ACL in reverse order but that did not work.could you please explain it why is it so?access-list 101 extended permit ip 10.11.20.0 255.255.255.0 10.11.11.0 255.255...
Thank you for the reply but i want to allow traffic from outside to inside and i did allowed it using ACL. I tried with applying ACL on different direction and as you can see above, in which i succeeded in one option.ping workingciscoasa(config)#sh r...
