Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,
we are replacing FMC 1500 with 4500, what are the steps do I need to follow in order to configure everything like sensors, policies from 1500. how do I sync the config from 1500 to 4500?
can we export backup file from 1500 and impo...
Hello,
today we got new FMC 4500 devices. we tried to configure initial setup but it doesn't show anything. we followed the Cisco document. can anyone help me with this?
Thanks
Harish
today am able to attach with KVM and I configure the ip as 192.168.45.45 and i tried to open it on the browser ,but GUI doesn’t open. it just said “this page can’t be displayed “
Hello Marvin,
today am able to attach with KVM and I configure the ip as 192.168.45.45 and i tried to open it on the browser but GUI doesn’t open it just said no connection error.
yes, i changed the Ip address as per doc(eth0 to my pc).
if everything correct FMC initial config window should pop up automatically right? are do we configure through command line?
